Ankom TDF Dietary Manual de usuario descargar pdf (Pagina 74)

Operator’s Manual

pg. 74 Rev E 12/2/14

The value on the Mixer Duty Cycle screen is only used during Diagnostics and in

an AOAC 2009.01/2011.25 assay during the 16 hour Amylase/AMG digestion and

Trizma phases. The default value for the specified AOAC 2009.01/2011.25 phases

is 50.

Heater Test

When you press the Heater Test button on the Diagnostics screen, the following screen will be displayed.

With the Paddle Heater Power Enable button set to “on”, pressing any of the Paddle 1 through Paddle 6 buttons will turn the

heat on for the specific paddle. Pressing the In-line Heater button will turn the In-line Heater on and light the LED located

below the Touch Screen Display on the Control Panel. The heater temperatures are shown below each heater button.

After completing the Heater Test you should turn all heaters off.

Faults

When you press the Faults button on the Diagnostics screen, the Faults screen is displayed. See the “Fault Handling” section of

this manual for more information.

Pressures

When you press the Pressures button on the Diagnostics screen, the following screen will be displayed.

The readings shown on this screen for the input pressure and the lines to all six stations represent the absolute pressure. These

values will dynamically change as the pressure changes.

Pressure Monitor (psi)

←

xx.x

Line 1

xx.x

Line 2

xx.x

Line 3

xx.x

Line 4

xx.x

Line 5

xx.x

Line 6

xx.x

Input Pressure

xx.x

Vacuum Sensor

←

Heater Test

Paddle Heater

Power Enable

(off)

In-line Heater

(off)

Paddle 1

(off)

Paddle 2

(off)

Paddle 3

(off)

Paddle 4

(off)

Paddle 5

(off)

Paddle 6

(off)

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 95 96

Comentarios a estos manuales

Sin comentarios

Ankom TDF Dietary Manual de usuario Pagina 74

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Ankom TDF Dietary